Before connecting ZKTeco controllers to TRASSIR, you need to turn it on, connect it to your local network, and configure its network settings. To do this, open Network Settings -> Cloud Settings in the controller menu and set the following values:
- Server address - TRASSIR server IP address, to which the controller will be connected;
- Port - the default value is 8899;
- HTTPS - enabled.
After that, open the System settings and set the following value:
- Device Type Setting - Access Control Terminal.
Tip
In order to increase Access Control security, it is recommended to create a new user with the administrator privileges and use it to connect to TRASSIR Access Control.
- TRASSIR Access Control supports not all authentication mode, available on ZKTeco terminals. You can find a list of available modes in the reader settings after the controller's connection.
- The card numbers read out on the ZKTeco controllers can be used for authentication on the Hikvision controllers, working on the Wiegand-26 interface, and vice versa.
- The fingerprints captured by other manufacturers' terminals are not supported on ZKTeco terminals. In case you use other manufacturers' controllers, "its own" fingerprints should be loaded to each controller.
- ZKTeco controllers do not check uploaded persons photos.
